Cabletron Systems CSMIM-T1 Administrator's Manual page 120

Chapter 7 Setting Asynchronous Port Values
The
Interface Protocol
Annex negotiates. You can select a single button or any
combination of the following buttons:
atcp
ipcp
ipxcp
Protocol.
specifies the Compression Control Protocol.
ccp
The box uses the
AppleTalk
specifies the AppleTalk hint used by the Annex on a
Node ID
specific port. You can enter an ID in decimal or hexadecimal
notation. Each ID has two parts separated by a dot:
A network address ranges from 0 to 65534 (0x0000 to
0xFFFE).
A node address ranges from 0 to 254 (0x00 to 0xFE).
For example, 191.253, 0x00FR.253 and 191.0xFD designate
the same address. You can enter numbers ranging from 0 to
65534.255.
The box allows you to specify arguments for
Rlogin/Telnet
connections.
Argument
or
Telnet
address here. You can enter up to 100 characters.
The box allows you to choose a host and the
Dedicated
applications for ports connected directly to a host.
Host Address
will connect.
7-10
the remote addresses. The connection is denied for a
remote SLIP client.
If you select the
DHCP server to request a remote address.
If you select the
address at the other end of the serial line.
box lists the control protocols for which the
specifies AppleTalk Protocol Control Protocol.
specifies Internet Protocol Control Protocol.
specifies the Internet Packet Exchange Control
Node ID
contains the commands used when you select
in the box. You should include a host name or
Mode
contains the IP address of a host to which this port
CSMIM/Micro-CS Management Application Guide
button, the Annex contacts a
dhcp
button, the Annex uses the IP
Local
field.
and
rlogin telnet
Rlogin
or
rlogin telnet