Table of Contents
Advertisement
metric
defines the hop count to the remote end of the serial line when
to
or
. Modify this parameter only if you want the Annex to use a route
slip
ppp
other than the SLIP or PPP interfaces to the remote end.
Type
Async
Values
1 to 15
Default 1
Lists
Async Port, PPP, SLIP
min_unique_hostnames
specifies whether you can identify a host in the host table by entering a
minimal string rather than the full host name.
Type
Annex
Values
enabled or disabled
Default disabled
Lists
Annex Only, Modem
mode
sets the mode for access to an asynchronous port. For more information
about modes, see the CSMIM/MicroCS Administrator's Guide for UNIX and
the Annex Administrator's Guide for DOS . You can enter:
to allow a port connected to a terminal or incoming modem
cli
access to CLI. CLI provides access to the network and
connections to other hosts via the
commands
to indicate that a port provides access to modems, serial
slave
line printers, and other serial devices attached to an outgoing
port. It does not provide access to the CLI.
adaptive
initiated via an Annex, the port enters CLI mode. If a connection
is initiated via a port server, the port enters slave mode.
to indicate that a port has no connection. You should
unused
enter
unused
to specify that a port can perform as a network interface
slip
using SLIP. IP packets are encapsulated by SLIP.
CSMIM/Micro-CS Management Application Guide
.
The
tn3270
option_key
to allow slave and CLI capabilities. If a connection is
if a port is not connected to a device.
,
telnet
connect
command is available only when
is set to an appropriate value.
is set
mode
,
and
rlogin
tn3270
19-57
Advertisement
Table of Contents
