Cabletron Systems CSMIM-T1 Administrator's Manual page 331

CallDef_slip_mtu_size
sets the maximum transmission unit (MTU) size for a PPP SLIP/CSLIP
connection to an ISDN Primary Rate Annex. This parameter forces the
SLIP interface to use large (1006) or small (256) MTUs.
Type Annex
Values large or small
Default small
Lists Annex Only, SLIP, Call Defaults
CallDef_slip_no_icmp
discards ICMP packets directed to the SLIP link. This parameter allows the
ISDN Primary Rate Annex to reduce unnecessary traffic and messages
over the SLIP link.
Type Annex
Values enabled or disabled
Default disabled
Lists Annex Only, SLIP, Call Defaults
CallDef_slip_ppp_
security
controls dial-up SLIP/PPP access to an ISDN Primary Rate Annex. When
and
enable_security
will use the ACP security server. The Annex determines whether CLI users
are authorized to execute SLIP or PPP commands.
Type Annex
Values enabled or disabled
Default disabled
Annex Only, PPP, SLIP, Security, Call Defaults, Sync Call
Lists
Defaults
CallDef_slip_subnet_
mask
contains the ISDN Primary Rate Annex's IP subnet mask for a SLIP
interface. The parameter's default is based on the network portion of the
CSMIM/Micro-CS Management Application Guide
CallDef_slip_ppp_security
are set to
enabled
, SLIP and PPP calls
19-31