Using The Call Defaults Window - Cabletron Systems CSMIM-T1 Administrator's Manual

Chapter 8 Setting ISDN Primary Rate Annex Values
Internal defaults for all parameters that are not set. The Annex
uses these values unless you set Call Default and/or Session
Parameter Block values.
Call Default parameters settings that apply to all incoming calls.
These parameters are similar to those you use for
asynchronous ports.
Session Parameter Blocks (SPB), stored in the pri section of
your Annex configuration file, include Setup criteria and
parameter values that the Annex uses to match incoming calls
and override existing parameter values.
You can use Annex Manager's Customize mode to set individual ISDN
Primary Rate Annex parameters. Annex Manager's Setup mode provides
several windows you can use for ISDN Primary Rate Annexes:
The
Call Defaults
used PRI parameter and modem settings.
The
Channels
each B-channel.
The
T1/PRI Line
office switch that your telephone company provides.
The
Security
For detailed information about this window, see .
This chapter describes these windows in the following sections:

Using the Call Defaults Window

Using the Channels Window
Using the T1/PRI Line Window
Using the Call Defaults Window
The window lets you change commonly-used parameter settings
Call Defaults
for ISDN Primary Rate Annexes. In addition, you can use the
window to view and change internal modem definitions.
8-2
For detailed information about SPBs, refer to the Remote
Annex 6300 Supplement to the Annex Administrator's
Guide for UNIX .
window allows you to set the most commonly
window allows you to set a remote address for
window allows you to select the type of central
window controls security systems on the Annex.
CSMIM/Micro-CS Management Application Guide
Edit Modems