Cabletron Systems CSMIM-T1 Administrator's Manual page 362

Chapter 19 Annex Parameters
active on ports that do not have a DSR signal (ports with partial modem
control lines).
Type Async
Values enabled or disabled
Default disabled
Lists Async Port, Flow Control, Modem
net_inactivity
defines the amount of time an asynchronous interface port can remain
inactive before the port is reset. The
whether the number you enter here is in minutes or seconds.
Type Async
Values 0 to 255
Default 0
Lists Async Ports, Idle Timer, PPP, SLIP
net_inactivity_units
determines the unit of time used for the port's serial protocol inactivity timer.
Type Async
Values minutes or seconds
Default minutes
Lists Async Port, PPP, SLIP
network_turnaround
controls the number of seconds that an Annex waits for a response from a
security server. An algorithm defines the actual time, which is usually longer
than the number of seconds in this parameter. This parameter works only
when
enable_security
Type Annex
Values 1 to 255 seconds
Default 2 seconds
Lists Annex Only, Security
19-62
is set to
enabled
You should not enter a high number here unless you need
a long timeout for contacting a slow host or for waiting
for a slow host's response to a security request.
CSMIM/Micro-CS Management Application Guide
net_inactivity_units
.
parameter determines