Table of Contents
Advertisement
VIEWING AND CHANGING PARAMETERS
The
and
Show
Set
parameters. These commands appear as push buttons in the main window
and as entries in the Configure menu.
parameters that comprise parameter groups and lists.
information;
Set
This chapter describes
Viewing Parameter Values
Changing Parameter Values
Identifying Errors
Before You Use Show and Set Commands
The
and
Show
Set
window. Before you use
1
Create an Annex list and select one or more Annexes from the
list.
and
Show
that you select.
2
Choose a
The appropriate group or list appears in the box.
3
Select a single parameter group or one or more individual
parameters.
Once you enter required information in the main window, you can use the
and
commands. For detailed information about the main window,
Show
Set
refer to .
CSMIM/Micro-CS Management Application Guide
CHAPTER 13
commands allow you to view and change Annex
lets you view and change parameter values.
and
Show
commands are based on information you enter in the main
or
Show
display information only for connected Annexes
Set
Parameter Option
and
Show
in the following sections:
Set
, you need to:
Set
.
display values for the
Set
lets you view
Show
13-1
Advertisement
Table of Contents
