Cabletron Systems CSMIM-T1 Administrator's Manual page 370

Chapter 19 Annex Parameters
ppp_acm
specifies which of the first 32 bytes (0x0 to 0x1F) of the ASCII character
set can be sent as clear text and which should be protocol-escaped.
Type Async
Values 8 character hexadecimal
Default 00000000
Lists Async Port, PPP
ppp_ipx_network
defines a unique network number for an IPX PPP connection assigned to
a specific port. The number is negotiated when the IPX PPP connection is
established. If the number at one end is zero (0), the number at the other
end will be used. You can enter an 8-digit hexadecimal number here.
Type Async
Values 0x00000001 to 0xFFFFFFFF
Default 00000000
Lists Async Port, PPP
ppp_ipx_node
defines a unique node number for an IPX PPP connection assigned to a
specific port. You can enter a 12-digit hexadecimal number here, using
dashes to separate sets of two numbers (e.g., 00-00-00-00-00-00). You
cannot use a number that has 1 in the last bit of the first octet, since these
numbers are reserved for multicast addresses, or
0xFF-FF-FF-FF-FF-FF, which is reserved as a broadcast node address.
Type Async
Values 0x00-00-00-00-00-00 to 0xFF-FF-FF-FF-FF-FE
Default 00-00-00-00-00-00
Lists Async Port, PPP
ppp_mru
defines the maximum receive unit (MRU) that the Annex requests as its
local MRU.
Type Async
Values 64 to 1500
Default 1500
Lists Async Port, PPP
19-70 CSMIM/Micro-CS Management Application Guide