Cabletron Systems CSMIM-T1 Administrator's Manual page 361

name_server_1
defines the type of name service used with the primary name server. This
parameter works only when you specify a host in
Type Annex
Values dns, ien_116, none
Default none
Lists Annex Only, Nameserver
name_server_2
defines the type of name service used with the secondary name server.
The Annex uses this service when the service specified in
not available. This parameter works only when you specify a host in
.
pref_name2_addr
Type Annex
Values dns, ien_116, none
Default none
Lists Annex Only, Nameserver
nameserver_broadcast
defines whether the Annex broadcasts a name server request if the
preferred name servers do not respond.
Type Annex
Values enabled or disabled
Default disabled
Lists Annex Only, Modem
need_dsr
allows an Annex to use the DSR (Data Set Ready) signal to determine
whether a device is attached to the corresponding asynchronous line. The
Annex will not allow connection to a slave line port and will not activate CLI
until the DSR signal is active. If DSR is deactivated, the connection to a
slave line is terminated and CLI is deactivated.
If you choose
disabled
line, and is not required to activate a CLI line. DSR is always considered
CSMIM/Micro-CS Management Application Guide
, the DSR signal is not required to connect to a slave
.
pref_name1_addr
name_server_1
is
19-61