ppp_ncp
specifies the protocols that run on the interface. The Annex negotiates only
for those protocols that are specified here. You can select a single protocol,
all protocols, or a combination of two protocols from the following list:
all
ipcp
atcp
ipxcp
ipcp-atcp
ipcp-ipxcp
atcp-ipxcp
Type
Async
Values
all, ipcp, atcp, ipxcp, ipcp-atcp, ipcp-ipxcp, atcp-ipxcp
Default ipcp
Lists
Async Port, PPP
ppp_password_remote
defines a PPP port user's password For security reasons, Annex Manager
displays this parameter's value as
Type
Async
Values
0 to 16 characters
Default unset
Lists
Async Port, PPP, Security
ppp_security_protocol
defines the security check for the peer that the Annex requires before it
starts the network control protocol. If the Annex wants to use security and
the peer refuses, the Annex closes the link. You can enter:
to use challenge-handshake protocol.
chap
to use password authentication protocol.
pap
chap/pap
password authentication protocol.
.
none
CSMIM/Micro-CS Management Application Guide
to use both challenge-handshake protocol and
or
.
set
unset
19-71