Cabletron Systems CSMIM-T1 Administrator's Manual page 342

Chapter 19 Annex Parameters
do_compression
starts TCP/IP header compression on a SLIP link. When you choose
the Annex negotiates for TCP/IP compression for both sides of the
connection.
Type Async
Values enabled or disabled
Default disabled
Lists Async Port, PPP, SLIP
dtr_signal
controls the DTR (Data Terminal Ready) signal for the port. Entering a value
for an idle port causes an error condition.
Parameters window to prevent the reset process and to use the
parameter value you entered.
Type Async
Values unknown, high, low
Default unknown
Lists Async Port
echo
directs an Annex to echo all characters as a user types. This parameter
applies only to the CLI level.
Type Async
Values enabled or disabled
Default disabled
Lists Async Port, Command Line Editing
enable_security
allows you to activate the security system.
Type Annex
Values enabled or disabled
Default disabled
Annex Only, AppleTalk, IPX, PPP, SLIP, Security,
Lists
Virtual CLI
19-42
I f you change this value and then reset a port or reboot
an Annex, this parameter will return to its original default
values. Therefore, you must press
CSMIM/Micro-CS Management Application Guide
enabled
in the Reset
Cancel
,