Cabletron Systems CSMIM-T1 Administrator's Manual page 296

Chapter 18 Annex Manager and SNMP
Object Name
rs232PortInSpeed
rs232PortOutSpeed
rs232AsyncPortParity
rs232AsyncPortStopBits
rs232SyncPortClockSource
rs232SyncPortInterrupted
Frames
rs232SyncPortAborted
Frames
Setting Port Speed
The
rs232PortInSpeed
for the Annex's asynchronous ports.
To set the port to autobaud, you must first set
rs232AsyncPortAutobaud
rs232PortInSpeed
to zero when
value error.
To disable autobaud, you must first set the port speed to a
non-zero value, and then set
This ensures that the port is not left in a state without a declared
speed.
18-10
Table 9. RFC 1317 RS-232 MIB Objects
Restrictions
Setting one sets both.
Can set only to a
supported value. See
Setting Port Speed
below.
none (1)
space (5)
(1)
dynamic (4)
(1)
Accepts
only
Not supported
Not supported.
,
rs232PortOutSpeed
to
enabled (1)
or
rs232PortOutSpeed
rs232AsyncPortAutobaud
CSMIM/Micro-CS Management Application Guide
, or
mark (4),
all map to
none
maps to
one
external (2)
, and
rs232AsyncPortAutobaud
and then set either
to zero. Setting the port speed
is disabled results in a bad
rs232AsyncPortAutobaud
Read Object
Limitations
None
Returns only
, , or
none (1) odd (2)
even (3)
Returns only
one
, or
(1), two (2)
one-and-half (3)
Returns
internal (1)
or
external (2)
None
None
are related
to
disabled(2)
.