Table of Contents
Advertisement
Chapter 20 Troubleshooting
"Parameter does not exist" Message?
Not all parameters apply to all Annex hardware configurations or all
software releases. Since Annex Manager must support all parameters for
all Annex hardware and software, you may see this message when you
compare one Annex's port configuration to a port on a different Annex,
when you copy parameters from one Annex to another, or when you use
the
or
commands.
Show
Set
SNMP Communication
In order for Annex Manager to communicate with an Annex, the Annex's
SNMP agent must be up and the specified community string must match
one of the Annex's community strings. To perform operations which will
change parameters (e.g., the
on the Annex must be set to
the non-SNMP
na
OpenLook/OpenWindow Issues
When you run Annex Manager in an OpenLook/OpenWindows
environment, make sure that the latest xnews server patch is installed. If
the application appears to hang after simple actions like a menu selection,
it is likely that the xnews server and OpenLook window manager are
causing the problem.
OpenLook Window Manager Close Menu Item
Do not use the OpenLook Window Manager
menu bar. Use the Annex Manager
OpenLook Window Manager menu option, Annex Manager will terminate
unexpectedly. This termination is not always immediate.
Ethernet Interface Numbering
Annex Manager numbers the ethernet interfaces starting with 1. The
tools number the ethernet interfaces starting with 0 (zero).
admin
20-4
command), the
Set
. You can set this parameter only by using
Y (Yes)
and
tools.
admin
CSMIM/Micro-CS Management Application Guide
allow_snmp_sets
menu option from the
Close
buttons instead. If you use the
Close
parameter
and
na
Advertisement
Table of Contents
