Table of Contents
Advertisement
Chapter 20 Troubleshooting
Annex Manager cannot communicate with an Annex unless
the Annex is running the SNMP daemon process. You should
use the
mode from the direct connection to the Annex, and then use
the
proc CLI
example, this line may read:
407 0 S0 7e8d0 103c 7f7f4 12 12 0
If there is no
Check the Annex's configuration file to make sure there is
at least one
change the configuration file.
Check the
tool. If this parameter indicates that SNMP is disabled, the
Annex discards SNMP messages. You should remove
snmp
reboot the Annex.
Did you enter the correct community name?
The community name you enter must match an entry in the
Annex's configuration file. Check the configuration file and look
for all
snmp community
different community names.
Are the Annex and Annex Manager's workstation on different
subnetworks?
Using the
process is running. If it is not, the Annex may not be able to
reply to the messages received from Annex Manager. Use the
superuser admin CLI
parameter to
Annex Manager Command Availability
Annex Manager provides Setup and Customize modes. Customize mode
includes all commands except Setup mode windows. Setup mode does
not include the
View Script
User-defined Parameter Groups
commands, you must select
20-2
command to go to the
su CLI
command to find a line for the
process:
snmpd
snmp community
disabled_modules
from the parameter's list of disabled modules and
definitions. The Annex can have up to four
superuser proc CLI
command to change the routed configuration
and reboot the Annex.
yes
,
Create Script
and
Site Parameters
Customize
CSMIM/Micro-CS Management Application Guide
superuser
18 0:00.017 ? snmpd.
defined. Reboot the Annex if you
parameter using the
command, check to see if the routed
,
,
Execute Script
commands. To use these
from the Mode menu.
or
administrative
process. For
snmpd
or
admin
,
,
Compare
Copy
Set
na
,
,
Show
Advertisement
Table of Contents
