Cabletron Systems CSMIM-T1 Administrator's Manual page 380

Chapter 19 Annex Parameters
retrans_limit
indicates the number of times an Annex retransmits a packet before it
notifies a user about a network failure. This parameter works only for the
LAT protocol.
Type Annex
Values 4 to 120
Default 8
Lists Annex Only, LAT
ring
controls the audible ring for incoming calls. You can use this parameter only
when you select
Type T1 DS0
Values enabled or disabled
Default
Lists T1_DS0
rip_accept
defines the networks for which the Annex accepts advertised routes. You
can enter ,
all none
preceded by
include
Type Interface
all, none, or one to eight IP addresses preceded by include
Values
or exclude
Default n/a
Lists Enet Port, Async Port, Routing
rip_advertise
defines the networks for which the Annex will advertise routes. You can
enter , , or a list of one to eight IP addresses in decimal format,
all none
preceded by
include
Type Interface
all, none, or one to eight IP addresses preceded by include
Values
or exclude
Default all
Lists Enet Port, Async Port, Routing
19-80
or
wink immediate
, or a list of one to eight IP addresses in decimal format,
or .
exclude
or .
exclude
CSMIM/Micro-CS Management Application Guide
for .
sigproto