Table of Contents
Advertisement
W
ARNING
Understanding the LAT Window
The
window uses the following fields:
LAT
Server Name
you enter should match the VMS host's node name used in the
HIC configuration file. The default value is
server's physical ethernet address (e.g.,
Remote Group Codes
that can access local services offered by an Annex. To access
these services, the Annex must have at least one enabled
group code that matches the service's group codes. You can
enter
all
1, 5, 7) or a range of numbers separated by dashes (e.g. 1, 5,
200-255). You can use any number between 0 and 255.
Virtual CLI Group Codes
assigned to virtual CLI users. All virtual CLI users have the
same group code. You can enter
to disable all groups, a series of numbers separated by
CSMIM/Micro-CS Management Application Guide
Figure 11-5. LAT Window
identifies the Annex in the LAT protocol. The name
specifies LAT protocol remote group codes
,
, a series of numbers separated by commas, (e.g.,
none
specifies remote group codes that are
Using the LAT Window
followed by the
LAT
LAT_080002BF0020
to enable all groups,
all
).
none
11-7
Advertisement
Table of Contents
