Cabletron Systems CSMIM-T1 Administrator's Manual page 14

Preface
Chapter 5, Setup Mode Basics describes the windows and
special features of the Setup mode.
Chapter 6, Selecting General Settings discusses how to
use the two General windows in Setup mode to set the
most commonly-used Annex parameters.
Chapter 7, Setting Asynchronous Port Values explains
how to select and edit asynchronous port settings and
modem definitions in Setup Mode.
Chapter 8, Setting ISDN Primary Rate Annex Values
describes how to set frequently-used Call Default
parameters, assign remote addresses to channels, and
set the T1/PRI line switch type.
Chapter 9, Editing Modem Definitions explains how to edit
a modem definition in your configuration files.
Chapter 10, Setting Security Values describes how to set
frequently-used Annex security settings.
Chapter 11, Using the AppleTalk, IP, IPX and LAT Windows
explains how to set frequently-used values for these
protocols.
Part 3, Customize Mode:
Chapter 12, Using and Creating Parameter Groups
describes how to create your own parameter listings that
you can use in any Annex Manager session.
Chapter 13, Viewing and Changing Parameters provides
instructions for using the and commands.
Show Set
Chapter 14, Viewing, Creating, and Executing Scripts
explains the commands that allow you to create a set of
parameter values, to store them as a script, and to apply
a script's values to one or more Annexes.
Chapter 15, Comparing and Copying Parameters and
Values discusses the commands that allow you to verify
parameters and values in existing Annexes and scripts,
and to apply one Annex's parameter values to other
Annexes.
2 CSMIM/Micro-CS Management Application Guide