Cabletron Systems CSMIM-T1 Administrator's Manual page 386

Chapter 19 Annex Parameters
session_limit_port
specifies the maximum number of active sessions the Annex allows on a
port at one time. You can enter
Type Async
Values -1 to 16
Default 3s
Lists Async Port, Basic Async Port,
short _ break
allows an Annex to return a user to the CLI prompt after receiving a break
of less than two seconds.
Type Async
Values enabled or disabled
Default disabled
Lists Async Port, Idle Timer
sigproto
indicates the signal protocols supported by each DS0 T1 channel.
Type T1 DS0
loop-loop, loop-none, none-loop, ground-ground,
Values ground-none, none-ground, wink-wink, wink-none,
none-wink, immed-none, none-immed, none-none.
Default loop-loop
Lists T1_DS0
slip_allow_dump
enables an Annex to dump its operational code across a SLIP link.
Type Async Port
Values enabled or disabled
Default enabled
Lists Async Port, SLIP
slip_load_dump_host
contains the IP address of the host from which an Annex receives a load
or to which it sends dumps over the SLIP interface. If you entered
19-86
to indicate that there is no maximum set.
-1
CSMIM/Micro-CS Management Application Guide
and a
sl