Table of Contents
Advertisement
Chapter 6
Selecting General Settings
Using the General Window
The
window includes basic Annex information in
General
and
boxes.
Time
The
box uses the following fields:
Boot Info
Default Host
all services unless you enter host addresses in the
(continued
field displays the current address in the Annex's
Host
pref_load_addr
fields are
Host
fields to the address in the
addresses using the
Load Sequence specifies available network interfaces and the
order in which they are used for a down-line load or an up-line
dump. You can list more than one interface by using commas
to separate interface names. You can enter:
to specify a local area network.
net
sl + port number
and a port number, you must enter an address in the
sl
slip_load_dump_host
to instruct an Annex to boot its image from the Flash
self
ROMs. Since the Annex cannot dump back to itself, you
should include a secondary interface here by entering
self,net
Boot Image contains the image file name loaded by default
when the Annex is booted. This name can use up to 100
characters.
Config File defines the name for the configuration file
maintained on the boot host. The Annex uses this file for
information on gateways, rotaries, macros, and services. It
must reside in the
6-2
identifies the host used for the host server and for
) window. When this window first appears, the
parameter.
When you configure an Annex for the first time, the
Security Preferred Host
,
Host
Nameserver Alternate Host, Time Host, Logging Host,
. In this situation, Annex Manager sets those
0.0.0.0
General (continued)
(e.g.,
sl2
parameter.
or
self,sl+port number.
/usr/spool/erpcd/bfs
CSMIM/Micro-CS Management Application Guide
,
DHCP Preferred Host, Nameserver Preferred
field. You can change these
Host
window.
) to specify a SLIP line. If you enter
directory.
,
Boot Info, Logging
General
Default
and
Dump
Advertisement
Table of Contents
