Table of Contents
Advertisement
A Default Aging Timeout dialog box similar to the following appears:
5.
Enter the number of seconds that the SSR is to allow a learned MAC address to
remain in the Layer-2 lookup table.
You can specify from 15 to 1,000,000 seconds. The default is 300 seconds.
6.
Click OK.
As discussed in
"Setting Up a Default Aging Timeout" on page
timeout for learned MAC address entries that ports use by default. You may override this
default timeout if you want a port to use a different timeout interval. To override the
timeout interval on a port:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file's
Bridging Configuration object.
3.
Double-click the Aging Configuration object.
4.
In the list of aging objects that appears, double-click the Aging Timeout Interval
object. Then select the Configure Aging Timeout on a New Port object that appears.
A Set Aging Timeout dialog box similar to the following appears:
68, you can set an aging
Advertisement
Table of Contents
