Table of Contents
Advertisement
The
box defines flow control and line speed settings using the
Line Control
following fields:
The
Modem Signals
will use a modem for flow control. When you select the
button, the ports and modem use DCD, DTR, and DSR signals.
The Flow Control
to control data transfer. If you select:
None
control.
Hardware
Software
Other
set to a value that is not
select another setting here, you cannot select
The
Speed
between a device and an Annex. The value you enter must
match the device's baud rate. For a port with a modem,
is typically set to the maximum speed that the modem supports
(e.g.,
115200
The
box lists modem names and provides access to the
Modem
window.
The field in this box specifies the type of modem attached to
the ports you selected. You can display a list that includes all
modems defined in the Annex configuration file and in
files for the Annexes you selected.
CSMIM/Micro-CS Management Application Guide
For more information about modem speeds, refer to
the
and
Autobaud
the CSMIM/MicroCS Administrator'sGuide for UNIX .
box indicates whether the ports you selected
box specifies the type of signals an Annex uses
, the port does not use hardware or software flow
, the port uses CTS/RTS signals.
, the port uses xon/xoff signals.
displays if the Annexes you selected have flow control
box defines the baud rate of the asynchronous line
).
All Annexes do not support all port speeds.
Please refer to your Annex hardware guides
for detailed information.
This list displays names from the Annex
configuration file followed by names in any
file. If you edit a modem definition that
include
originates in an
Using the Edit Async Ports Window
parameters described in and to
Speed
,
Hardware
Software
file, Annex Manager copies the
include
On
, or
. If you
None
again.
Other
Speed
Edit Modem
include
7-7
Advertisement
Table of Contents
