Table of Contents
Advertisement
Chapter 18
Annex Manager and SNMP
Defining Parameters
You must define the
Annex before you can use Annex Manager.
Defining the disabled_modules Parameter
The Annex's
disabled_modules
during Annex software initialization (e.g., you can enter
these features off. You can use the
. If you disabled SNMP, the Annex will discard all SNMP
disabled_modules
messages sent to it and Annex Manager will not be able to retrieve any
information using SNMP. By default, the SNMP agent on the Annex is
enabled.
Defining the allow_snmp_sets Parameter
The Annex's default setting for the
parameter value changes because the set command's header transmits
the community string in clear text, which may be a security risk. To allow
Annex Manager to modify parameters through SNMP, you must use the
or
tools to change
admin
using SNMP.
Standard MIB Support
The Annex supports the following standard MIBs:
MIB-II (defined in RFC1213).
Character MIBs (defined in RFCs 1316, (Character MIB), 1317
(RS232-like MIB), and 1318 (Parallel Printer MIB)).
Ethernet MIB (defined in RFC 1398).
RIPv2 MIB (defined in RFC 1389).
AppleTalk MIB (defined in RFC 1243).
18-4
disabled_modules
parameter allows you to turn off certain features
allow_snmp_sets
Some standard MIB objects are not valid or meaningful
for the Annex. For detailed information, see Annex
Restrictions on Standard MIBs on page 18-6.
CSMIM/Micro-CS Management Application Guide
and
allow_snmp_sets
or
tools to verify and change
na
admin
parameter does not permit
allow_snmp_sets
to
. You cannot set this parameter
yes
parameters on the
,
,
to turn
LAT
PPP
SLIP
na
Advertisement
Table of Contents
