Table of Contents
Advertisement
Chapter 1
Installing Annex Manager
1
Create a directory in which to place the setup directory you
extract from the media. The setup directory contains installation
scripts, release notes, and a release version file. Type:
% mkdir annex/setup
% cd annex
2
Extract the setup directory from the media. Type:
xvf <tar-device-name> setup
3
Execute the setup/install script. Type
% setup/install
The script responds with a welcome message as shown in the
following example:
****************************************************
It is required that you run this script as root
*****************************************************
This command is used to install Annex Software (boot images, security, command line
management) and Annex Manager (X-Motif GUI management application). The
versions installed are:
At any question prompt you can escape to a shell by typing "!". When you exit that
shell you will bounce back to the question prompt. Many of the questions will have
default answers in square brackets; pressing carriage return will select the default.
Do you want to continue (y/n/q=quit) [y]:
4
Select the media type you want to use to install the products:
What type of install will be performed?
1. Floppy Disks
2. Tape
3. Tarfile previously copied to hard disk
4. Reinstall from previously extracted software on hard drive
5. Quit
5
After you select a media type, the installation script requests
further information based on your previous selection. The
example below shows you the questions that the installation
script asks for each media type:
1-2
Annex Software
R13.2
Annex Manager
CSMIM/Micro-CS Management Application Guide
R2.3
Advertisement
Table of Contents
