Cabletron Systems CSMIM-T1 Administrator's Manual page 363

newline_terminal
interprets carriage returns and line feeds for CLI. When you enter
a carriage return or a line feed terminates the input line and a carriage
return followed by a line feed terminates output lines. When you enter
, a line feed terminates both the input and the output lines.
enabled
Type Annex
Values enabled or disabled
Default disabled
Lists Async Port, Command Line Editing
node_id
contains the address an Annex tries to acquire at the start of an AppleTalk
session. If the address you enter here is in use, the Annex must acquire a
new node ID. This new ID is stored in non-volatile RAM. Each ID has two
parts, separated by a dot.
Type Annex
Values 0 to 65534.255
Default 0.0
Lists Annex Only, AppleTalk
option_key
enables AppleTalk-specific functions and parameters, the CLI
command, active RIP, dial-out routing, filtering, and IPX. These features
are available separately or in any combination. Each Annex requires a
unique key value for the features you choose. You must contact your
supplier to obtain the key value.
Lists Annex
Values option key value from your supplier
Default n/a
Lists Annex Only, Basic Annex, AppleTalk, IPX
output _ flow _ control
defines the method that a device uses to start or stop output from an Annex.
You can choose:
to disable flow control.
none
start/stop
characters.
CSMIM/Micro-CS Management Application Guide
to designate flow control by recognizing xon and xoff
,
disabled
tn3270
19-63