Cabletron Systems CSMIM-T1 Administrator's Manual page 310

Chapter 19 Annex Parameters
If you choose
port
parameter only when the
Type Annex
Values port or network
Default port
Lists Annex Only, Basic Async Port, Modem, Call Defaults
CallDef_char_erase
allows an ISDN Primary Rate Annex using CLI to display the character
erase for a video terminal. When you choose
looks as if it has been erased. If you choose
Rate Annex echoes the erase characters for a hard-copy terminal. It
displays a backslash (\), one or more deleted characters, and a slash (/).
For example, typing
Type Annex
Values enabled or disabled
Default enabled
Lists Annex Only, Cmd Line Editing, Call Defaults
CallDef_cli_imask7
allows an ISDN Primary Rate Annex to mask CLI input to seven bits. If you
choose , the ISDN Primary Rate Annex expects eight-bit ASCII input.
disabled
You should not choose
seven-bit characters.
Type Annex
Values enabled or disabled
Default disabled
Annex Only, Basic Async Port, Call Defaults, Modem,
Lists
Modem Internal
CallDef_cli_inactivity
specifies the number of minutes the ISDN Primary Rate Annex will remain
idle before disconnecting a CLI session. Entering
entering causes the ISDN Primary Rate Annex to disconnect as soon
255
19-10
, it sends a message from the port side. You can use this
CallDef_mode
asdf Delete Delete
unless the terminal can transmit only
enabled
CSMIM/Micro-CS Management Application Guide
parameter is set to
, a deleted character
enabled
, the ISDN Primary
disabled
displays as
g asdf\fd/g
disables the timer;
0
.
slave
.