Cabletron Systems CSMIM-T1 Administrator's Manual page 130

Chapter 8 Setting ISDN Primary Rate Annex Values
The
Local Address
on the ISDN Primary Rate Annex side of a link when the Annex
does not obtain the address from the host's
The
Subnet Mask
IP subnet mask. This field's initial display is based on the
network portion of the Annex's IP address.
The
PPP Interface Protocol
the Annex negotiates. You can select a single button or any
combination of the following buttons:
specifies AppleTalk Control Protocol.
atcp
specifies Internet Protocol Control Protocol.
ipcp
specifies the Internet Packet Exchange Control Protocol.
ipxcp
specifies the Compression Control Protocol.
ccp
specifies the MultiLink PPP Protocol.
mp
The
AppleTalk
specifies the AppleTalk hint used by the ISDN Primary
Node ID
Rate Annex. You can enter an ID in decimal or hexadecimal
notation. Each ID has two parts separated by a dot:
The
Rlogin/Telnet
and
telnet
Argument
Rlogin
name or address here. You can enter up to 100 characters.
The box defines activity and controls inactivity timers.
Time
The
Timer
8-6
field defines the IP address for a connection
field contains the ISDN Primary Rate Annex's
Entering an incorrect
problems.
box lists the control protocols for which
box uses the
A network address ranges from 0 to 65534 (0x0000
to 0xFFFE).
A node address ranges from 0 to 254 (0x00 to 0xFE).
For example, 191.253, 0x00FR.253 and 191.0xFD
designate the same address. You can enter numbers
ranging from 0 to 65534.255.
box allows you to specify arguments for
connections.
contains the commands used when you select
or in the
Telnet
box controls inactivity timers.
CSMIM/Micro-CS Management Application Guide
Subnet Mask
field.
Node ID
box. You should include a host
Mode
file.
acp_dialup
can cause routing
rlogin