Cabletron Systems CSMIM-T1 Administrator's Manual page 308

Chapter 19 Annex Parameters
CallDef_at_nodeid
specifies the Appletalk hint used by an ISDN Primary Rate Annex. You can
enter an ID in decimal or hexadecimal notation. Each ID has two parts
separated by a dot:
A network address ranges from 0 to 65534 (0x0000 to
0xFFFE).
A node address ranges from 0 to 255 (0x00 to 0xFE).
For example,
191.253
Type Annex
Values 0 to 65534.255
Default 0.0
Lists Annex Only, AppleTalk, Call Defaults
CallDef_at_security
turns on ACP service for an AppleTalk session. When you choose
for this parameter and for
ACP to get security information about the client, including authentication,
logging, and zone access information. If you choose
Primary Rate Annex uses only local security.
Type Annex
Values enabled or disabled
Default disabled
Lists Annex Only, AppleTalk, Call Defaults
CallDef_attn _ string
defines a control character sequence that returns users to the CLI prompt.
Users can define a temporary control character sequence using the CLI
command.
stty attn
Type Annex
Value
Ctrl
" " (null string) or
Default
Annex Only, Cmd LIne Editing, Modem, Modem Internal,
Lists
Call Defaults
19-8
, and
0x00BF.253
enable_security
+ any character, up to 16 characters
Ctrl
CSMIM/Micro-CS Management Application Guide
designate the same address.
191.0xFD
, the ISDN Primary Rate Annex uses
+
(for vcli connections)
A
enabled
, the ISDN
disabled