Chapter 16 Booting And Resetting Annexes; Booting Annexes; Displaying The Boot Window - Cabletron Systems CSMIM-T1 Administrator's Manual

BOOTING AND RESETTING ANNEXES
When you use a command that changes parameter values, you can use
the or commands to apply new Annex configurations. You can use
Boot Reset
to notify Annex users about a boot or reset, or send any message
Broadcast
to all devices connected to the Annexes you select. This chapter explains
these commands in the following sections:

Booting Annexes

Resetting an Annex Configuration
Broadcasting Messages
Configuring PRI Internal Modems
For detailed information about Annex configurations, refer to your Annex
hardware guide.
Booting Annexes
The command allows you to boot one or more active Annexes. You can
Boot
choose to boot Annexes immediately, set a time in the future for the boot
to take place, and send an explanatory message to all users. This section
gives you directions for using the

Displaying the Boot Window

Understanding the Boot Window Format
Booting an Annex
Displaying the Boot Window
Displaying the Window
The command originates in the Configure menu. To display the window:
Boot
CSMIM/Micro-CS Management Application Guide
CHAPTER 16
The command terminates all active connections to
Boot
an Annex. You cannot return to the main window once
you display the
command. It includes:
Boot
window.
Boot
16-1