Cabletron Systems CSMIM-T1 Administrator's Manual page 354

Chapter 19 Annex Parameters
long _ break
allows an Annex to return a user to the CLI prompt after receiving a break
signal of more than two seconds. If you enter
the break to the local application.
Type Async
Values enabled or disabled
Default enabled
Lists Async Ports, Idle Timer
loose_source_route
controls the Loose Source Routing protocol, which defines a sequence of
IP addresses that a datagram must follow. You can select
When you select enable, the Annex:
Forwards IP packets that have the
option set.
Forwards packets with the
only if it can reach the next routing address directly.
Drops packets that do not have either setting and sends an
ICMP
Destination Unreachable
code.
If you enter
disabled
or
Record Strict Source Routing and Record
destination. If it is not the destination, it drops these packets and sends the
same ICMP type message and code.
Type Annex
Values enabled or disabled
Default enabled
Lists Annex Only, Security
map
controls mapping of DS0s between the T1 Network Interface and the T1
Drop and Insert Interface, as well as mapping of modems to the T1 Drop
and Insert Interface and the T1 Network Interface.
19-54
, the Annex accepts packets with
Loose source routing may be a security problem if you
use filters on your network router. If you are concerned
with security, you should set this parameter to
CSMIM/Micro-CS Management Application Guide
disabled
Loose Source Routing and Record
Strict Source Routing and Record
message with a
only when the Annex itself is the
, the Annex passes
or
enabled disabled
option
Source Route Failed
Loose Source Routing and
disabled
.
.