Cabletron Systems CSMIM-T1 Administrator's Manual page 306

Chapter 19 Annex Parameters
modem signal is active. This parameter is obsolete in Release 10.1.A and
in subsequent releases.
Type Async
Values enabled or disabled
Default disabled
Lists Async Port, Flow Control, Modem
broadcast_addr
specifies the IP address for Annex broadcasts (network.255 or network.0).
Type Annex
Values IP Address
Default 0.0.0.0
Lists Annex Only, Basic Annex
broadcast_direction
controls the direction in which an Annex sends an administrative broadcast
message. When you choose
connection's network side. If you choose
port side. You can use this parameter only when the
to .
slave
Type Async
Values port or network
Default port
Lists Async Port, Basic Async Port, Modem
bypass
removes the T1 engine from the network. You should enter
you first install an Annex or when the T1 engine is not functioning properly.
Type T1 DS1
Values enabled or disabled
Default disabled
Lists T1_DS1
19-6
, the Annex sends a message from the
network
CSMIM/Micro-CS Management Application Guide
, it sends a message from the
port
mode
parameter is set
when
enabled