Booting Annexes - Cabletron Systems CSMIM-T1 Administrator's Manual

Chapter 16 Booting and Resetting Annexes

Booting Annexes

You can use the
changes values for the
the boot takes place.
Using the Boot Command
To boot an Annex:
1 Create an Annex List and select one or more Annexes.
2 Select
Boot
The
Boot
to the main window unless you close the
3 Choose the
Refer to Defining Boot Operations earlier in this chapter for
detailed information about each option.
4 Enter information in the window's text fields.
Text fields may be required or may not be available, depending
on the
Boot Option
Immediate
Pref Load Addr, Boot Image
Delayed
a time in HH:MM format, or you can enter a plus sign (+)
followed by a time in HH:MM format to indicate an amount
of time in the future. You can enter text in the
Boot Image
You can enter more than one delayed request. However,
if you enter a second request for a time earlier than an
existing request, the selected Annexes will boot at the
earlier time and all other existing boot requests will be
deleted.
, you can enter text in the
Dump
, and
Image
, you can enter text in the
Abort
complete other fields.
16-6
command for one or more Annexes. Annex Manager
Boot
Pref Load Addr
from the Configure menu.
window appears (see Figure 16-1). You cannot return
you need.
Boot Option
you choose. If you selected:
, , or
Diagnostic
, you must complete the
, and
Boot Message
fields.
Boot Message
CSMIM/Micro-CS Management Application Guide
and
Pref Dump Addr
, you can enter text in the
Save in Flash
, and
Boot Message
Boot Time
fields.
Pref Load Addr, Pref Dump Addr
Boot Message
parameters before
window.
Boot
fields.
field. You can enter
Pref Load Addr
,
field. You cannot
,
Boot