Cabletron Systems CSMIM-T1 Administrator's Manual page 332

Chapter 19 Annex Parameters
Annex's IP address. Setting this parameter incorrectly can cause routing
problems.
Type Annex
Values IP address
Default 0.0.0.0
Lists Annex Only, SLIP, Call Defaults, Sync Call Defaults
CallDef_slip_tos
allows an ISDN Primary Rate Annex to send interactive traffic (such as
, , and
telnet rlogin
parameter provides a type-of-service based SLIP queuing.
Type Annex
Values enabled or disabled
Default disabled
Lists Annex Only, SLIP, Call Defaults
CallDef_tcp_keepalive
specifies the length of time an ISDN Primary Rate Annex connection must
be idle before sending keep-alive messages. A keep-alive message
contains no data, but solicits an acknowledgment from the other end of a
connection to determine whether the connection is still active. If the
recipient does not acknowledge the message after eight retries, the Annex
drops the connection. You can use
the keep-alive time to 120 minutes, or you can enter
keep-alive mechanism.
Type Annex
Values 0 to 255 minutes
Default 0 minutes
Lists Annex Only, Basic Annex, Call Defaults
CallDef_telnet_crlf
converts a carriage return in a Telnet session to a carriage return followed
by a line feed. If you enter
return followed by a null string.
Type Annex
Values enabled or disabled
Default disabled
LIsts Annex Only, Cmd Line Editing, Call Defaults
19-32
control sessions) before it sends other traffic. This
ftp
disabled
CSMIM/Micro-CS Management Application Guide
(Annex Manager's default value) to set
0
, a carriage return translates to a carriage
to disable the
255