Table of Contents
Advertisement
Chapter 16
Booting and Resetting Annexes
Resetting Annex Configurations
You can use the
configuration without booting. This command lets you reset port and
interface settings, several configuration file options, and name servers. This
section explains the
Displaying the Reset Window
Choosing a Reset Option
Resetting an Annex
Displaying the Reset Window
Displaying the Window
The
command originates in the Configure menu. To display this
Reset
window:
1
Create an Annex list in the main window.
For more information about Annex lists, see Saving and
Opening Annex Lists on page 4-13.
2
Select one or more Annexes from the list.
3
Hold the mouse button on the Configure menu, choose
release the mouse button.
The
Reset
The following example shows the
16-8
If you boot an active Annex, its status in the
main window's list changes to
In fact, although the Annex is not available
while boot processing takes place, a successful boot
does restore the Annex on your network. You can use
to restore the display.
Verify Annex State
command to change a specific Annex or port
Reset
command in the following sections:
Reset
window appears (see Figure 16-3).
CSMIM/Micro-CS Management Application Guide
window.
Reset
.
NOT REACHABLE
Reset
and
Advertisement
Table of Contents
