Cabletron Systems CSMIM-T1 Administrator's Manual page 321

CallDef_mode
sets the mode for access to an ISDN Primary Rate Annex. For more
information about modes, see the CSMIM/MicroCS Administrator's Guide
for UNIX and the Annex Administrator's Guide for DOS . You can enter:
to allow a dialed terminal or incoming modem access to CLI.
cli
CLI provides access to the network and connections to other
hosts via the
to specify that a connection can perform as a network
slip
interface using SLIP. IP packets are encapsulated by SLIP.
to specify that a connection can perform as a network
ppp
interface using PPP. IP packets are encapsulated by PPP.
to specify that a connection can perform as a network
arap
interface using ARAP.
auto-detect
incoming packet's protocol as IPX, PPP, ARAP or CLI.
to allow dial-in Novell access.
ipx
to allow an ISDN Primary Rate Annex to communicate
connect
with a LAT host via the
the
CallDef_dedicated_arguments
to allow
rlogin
the
rlogin
CallDef_dedicated_arguments
to allow an ISDN Primary Rate Annex to communicate
telnet
via the
CallDef_dedicated_arguments
to allow an ISDN Primary Rate Annex to communicate
tn3270
via the
CallDef_dedicated_arguments
Type Annex
cli, slip, ppp, arap, auto-detect, ipx, connect, rlogin, telnet,
Values
tn3270
Default cli
Annex Only, AppleTalk, Basic Async Port, Modem, PPP,
Lists
SLIP, Call Defaults, Sync Call Defaults
CSMIM/Micro-CS Management Application Guide
,
telnet connect
The
tn3270
option_key
to allow an ISDN Primary Rate Annex to identify an
connect
an ISDN Primary Rate Annex
command. This option works with the
command. This option works with the
telnet
command. This option works with the
tn3270
and
,
rlogin tn3270
command is available only when
is set to an appropriate value.
command. This option works with
parameter
.
parameter.
parameter.
parameter
.
commands
.
to communicate via
19-21