Cabletron Systems CSMIM-T1 Administrator's Manual page 394

Chapter 19 Annex Parameters
time_broadcast
defines whether the Annex broadcasts for the current time if the preferred
load host is not available or does not provide a time server.
Type Annex
Values enabled or disabled
Default disabled
Lists Annex Only, Time of Day
time_server_addr
lists the IP address that an Annex queries for time service. You can enter:
A loopback address (127.0.0.1) to disable time service queries.
A host address to send queries to a specific host.
A broadcast address to send queries to a specific network or
networks instead of sending a general broadcast to all
networks.
to direct the Annex to query the boot host.
0.0.0.0
Type Annex
Values loopback address, host address, broadcast address, 0.0.0.0
Default 0.0.0.0
Lists Annex Only, Time of Day
timezone_minuteswest
defines the time zone in which the Annex resides. You can enter a positive
number of minutes for time zones west of Greenwich Mean Time (GMT) or
a negative number for time zones east of GMT. For example, you would
enter for U.S. Eastern Standard Time, which is five hours west of GMT,
300
or -60 for Paris, which is one hour east of GMT.
Type Annex
Values positive or negative number of minutes
Default 300
Lists Annex Only, Time of Day
tmux_delay
provides the maximum number of milliseconds during which small packets
can accumulate to form larger packets. When the time expires, the
19-94 CSMIM/Micro-CS Management Application Guide