Cabletron Systems CSMIM-T1 Administrator's Manual page 323

to indicate that flow control is delegated to a lower level.
eia
Type Annex
Values none, XonXoff, hardware
Default hardware
Lists Annex Only, Flow Control, Modem, Call Defaults
CallDef_output_is_
activity
defines activity as output. If you enter
timer to when it sends output.
0
Type Annex
Values enabled or disabled
Default enabled
Annex Only, Idle Timer, Modem, Modem Internal, Call
Lists
Defaults
CallDef_output _ start _
char
defines the control character sequence that restarts output if
CallDef_output_flow_control
Type Annex
Value
Ctrl
Default
Ctrl
Lists Annex Only, Flow Control, Call Defaults
CallDef_output _ stop _
char
defines the control character sequence that stops output if
CallDef_output_flow_control
Type Annex
Values
Ctrl
Default
Ctrl
Lists Annex Only, Flow Control, Call Defaults
CallDef_port
defines the CLI prompt for an ISDN Primary Rate Annex. This parameter
uses formatting codes consisting of the percent character and a single
lowercase letter. You can combine these codes (e.g.
CSMIM/Micro-CS Management Application Guide
is set to
start/stop
+ any character
+
(displays as ^Q)
Q
is set to
start/stop
+ any character
+ (displays as ^S)
S
, the Annex resets the inactivity
enabled
.
.
) using up to 16
%a%c
19-23