Cabletron Systems CSMIM-T1 Administrator's Manual page 358

Chapter 19 Annex Parameters
dedicated
defined in the
port can communicate via
.
connect
to specify that a port can perform as a network interface
ppp
using PPP. IP packets are encapsulated by PPP.
to specify that a port can perform as a network interface
arap
using ARAP.
auto-detect
protocol and to convert to IPX, PPP, ARAP or CLI.
auto-adapt
or outgoing. For incoming packets, the port behaves as if it
were in
mode.
slave
to allow Novell dial-in, dial-out, and routing.
ndp
to allow dial-in Novell access.
ipx
to allow a port to communicate with a LAT host via the
connect
command. This option works with the
connect
parameter
to allow a port to communicate via the
rlogin
This option works with the
to allow a port to communicate via the
telnet
This option works with the
to allow a port to communicate via the
tn3270
This option works with the
Type Async
cli, slave, adaptive, unused, slip, dedicated, ppp, arap,
Values auto-detect, auto-adapt, ndp, ipx, connect, rlogin, telnet,
tn3270
Default cli
Async Port, AppleTalk, Basic Async Port, Dedicated Port,
Lists
IPX, Modem, PPP, SLIP, TN3270
19-58
to allow a port to communicate only with the host
dedicated_address
to allow a port to identify an incoming packet's
to allow a port to detect whether packets are incoming
mode. For outgoing packets, it operates in
auto-detect
.
CSMIM/Micro-CS Management Application Guide
and
dedicated_port
or but not via
,
telnet rlogin
dedicated_arguments
dedicated_arguments
dedicated_arguments
parameters. The
or
tn3270
dedicated_arguments
command.
rlogin
parameter.
command.
telnet
parameter
.
command.
tn3270
parameter
.