Table of Contents
Advertisement
Parameter settings
5.1
Hardware configuration
Hardware configuration
As default the RF170C communications module is not included in the device configuration of
the TIP Portal (STEP 7) or the hardware configuration of the SIMATIC Manager. You can
include the CM later using an HSP file in TIA or in the SIMATIC Manager-
If you work with other configuration software. a GSD / GSDML file is available for the
configuration. You will find the relevant GSD/GSDML files in Siemens Industry Online Support
for the ET 200pro.
5.2
Configuration via STEP 7 (Basic/Professional)
Configuration with the TIA Portal
You configure the RF170C is using the TIA Portal. To do this, drag the required ET 200pro
module (interface module/central module) to the device configuration from the hardware
catalog. Then drag the RF170C to the module. Note that the communications module can
only be operated in conjunction with an interface module or a central module.
Figure 5-1
SIMATIC RF170C
Operating Instructions, 02/2022, J31069-D0176-U001-A6-7618
Adding the RF170C in the device configuration
5
29
Advertisement
Table of Contents
