Hitachi H8S/2215 Series Hardware Manual page 24

Section
19.4 Input/Output Pins
Table 19.2 Pin
Configuration
19.6 On-Board
Programming Modes
Table 19.3 Setting On-
Board Programming
Modes
19.6.1 SCI Boot Mode
(HD64F2215)
Figure 19.6 SCI System
Configuration in Boot
Mode
19.6.2 USB Boot Mode
(HD64F2215U)
19.8.1 Program/Program-
Verify
19.8.2 Erase/Erase-Verify 585
Rev. 3.0, 10/02, page xxiv of lviii
Page
Description
Figure amended
564
Pin Name I/O
RES Input
FWE Input
MD2,MD1,MD0 Input
PF3,PF0,P16, Input
P14
TxD2 Output
RxD2 Input
USB+,USB- Input/Output
VBUS Input
UBPM Input
USPND Output
P36 Output
(Incorrect) Boot mode
571
(Correct) SCI boot mode(HD64F2215)
USB boot mode(HD64F2215U)
Amended
571 to
574
(Incorrect) Boot Mode
(Correct) SCI Boot Mode
572 Figure amended
1
01X
Note added to figure
Note: * FWE pin and mode pin input must satisfy the mode
programming setup time (t
when a reset is released.
Newly added
575 to
579
33th line changed as follows
583
Verify data can be read in words from the address to which a
dummy write was performed.
11th line changed as follows
Verify data can be read in words from the address to which a
dummy write was performed.
Function
Reset
Flash program/erase protection by hardware
Sets this LSI's operating mode
Sets this LSI's operating mode in
programmer mode
Serial transmit data output
Serial receive data input
USB data output
USB cable connection/disconnection detection
USB bus power mode/self power mode setting
USB suspend output
D+ pull-up control
H8S/2215 Series
FWE*
MD2 to 0*
Flash memory
= 200 ns)
MDS
HD64F2215
and
HD64F2215U
HD64F2215
HD64F2215U