Hitachi H8S/2215 Series Hardware Manual page 220

Bit Bit Name Initial Value R/W
7 to – 0
4
3 WE1B 0
2 WE1A 0
1 WE0B 0
0 WE0A 0
Writes by the DTC to bits 15 to 12 (FAE and SAE) in DMABCR are invalid regardless of the
DMAWER settings. These bits should be changed, if necessary, by CPU processing.
In writes by the DTC to bits 7 to 4 (DTE) in DMABCR, 1 can be written without first reading 0.
To reactivate a channel set to full address mode, write 1 to both Write Enable A and Write Enable
B for the channel to be reactivated.
MAR, IOAR, and ETCR are always write-enabled regardless of the DMAWER settings. When
modifying these registers, the channel for which the modification is to be made should be halted.
Rev. 3.0, 10/02, page 162 of 686
Description
– Reserved
These bits are always read as 0 and cannot be modified.
R/W Write Enable 1B
Enables or disables writes to all bits in DMACR1B, bits 11, 7,
and 3 in DMABCR by the DTC.
0: Writes to all bits in DMACR1B, bits 11, 7, and 3 in
DMABCR are disabled
1: Writes to all bits in DMACR1B, bits 11, 7, and 3 in
DMABCR are enabled
R/W Write Enable 1A
Enables or disables writes to all bits in DMACR1A, and bits
10, 6, and 2 in DMABCR by the DTC.
0: Writes to all bits in DMACR1A, and bits 10, 6, and 2 in
DMABCR are disabled
0: Writes to all bits in DMACR1A, and bits 10, 6, and 2 in
DMABCR are enabled
R/W Write Enable 0B
Enables or disables writes to all bits in DMACR0B, bits 9, 5,
and 1 in DMABCR by the DTC.
0: Writes to all bits in DMACR0B, bits 9, 5, and 1 in
DMABCR, are disabled
0: Writes to all bits in DMACR0B, bits 9, 5, and 1 in
DMABCR are enabled
R/W Write Enable 0A
Enables or disables writes to all bits in DMACR0A, and bits 8,
4, and 0 in DMABCR by the DTC.
0: Writes to all bits in DMACR0A, and bits 8, 4, and 0 in
DMABCR are disabled
0: Writes to all bits in DMACR0A, and bits 8, 4, and 0 in
DMABCR are enabled