Hitachi H8S/2215 Series Hardware Manual page 14

Section
13.7 SCI Select Function
Figure 13.24 Example of
Communication Using the
SCI Select Function
Figure 13.25 Operation of
Communication Using the
SCI Select Function
14.3.2 IDCODE Register
(IDCODE)
Table 14.3 IDCODE
Register Configuration
15.1 Features
•
Endpoint configuration
selectable
Rev. 3.0, 10/02, page xiv of lviii
Page
Description
Added
406
Note: * The selection signals (SEL_A and SEL_B) of the LSI
must be switched while the serial clock (M_SCK) is high after
the end bit of the transmit data has been send. Note that one
selection signal can be brought low at the same time.
Figure title amended
407
Added
Note: * The selection signals (SEL_A and SEL_B) of the LSI
must be switched while the serial clock (M_SCK) is high after
the end bit of the transmit data has been send. Note that one
selection signal can be brought low at the same time.
3rd line changed as follows
422
The HD64F2215, HD64F2215U, HD6432215A,
HD6432215B, and HD6432215C output fixed codes
H'0002200F, H'0003200F, H'001B200F, and H'001C200F,
respectively, from the TDO.
Code amended
(Incorrect) HD64F2215 code
(Correct) HD64F2215 code, HD64F2215U code
433 Replaced
The FIFO buffer for bulk transfer and isochronous transfer
has a double-buffer configuration
Total 1288-byte FIFO
—EP0s fixed: Control_setup FIFO, 8 bytes
—EP0i fixed: Control_in FIFO, 64 bytes
—EP0o fixed: Control_out FIFO, 64 bytes
—EPn selectable: Interrupt_in FIFO, variable 0 to 64 bytes
—EPn selectable: Bulk_in FIFO, 64 bytes x 2 (double-buffer
configuration)
—EPn selectable: Bulk_out FIFO, 64 bytes x 2 (double-buffer
configuration)
—EPn selectable: Isochronous_in FIFO, variable 0 to 128
bytes x 2 (double-buffer configuration)
—EPn selectable: Isochronous_out FIFO, variable 0 to 128
bytes x 2 (double-buffer configuration)
—EPn selectable: Bulk_in FIFO, 64 bytes x 2 (double-buffer
configuration)
—EPn selectable: Bulk_out FIFO, 64 bytes x 2 (double-buffer
configuration)
—EPn selectable: Interrupt_in FIFO, variable 0 to 64 bytes