Vlt-Peer-Lag Port-Channel - Dell S6100 Configuration Manual

Version
9.0.0.0
8.3.19.0
8.3.8.0
Usage Information The VLT domain ID must be the same between the two VLT devices. If the domain ID is not the same, a syslog
message generates and VLT does not launch.
Related Commands
•

vlt-peer-lag port-channel

Associate the port channel to the corresponding VLT peer port channel for the VLT connection to an attached device.
Syntax vlt-peer-lag port-channel id-number
Parameters
id-number
Defaults Not configured.
Command Modes INTERFACE PORT-CHANNEL
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.0.2.0
9.0.0.0
8.3.19.0
8.3.8.0
9.2(0.0)
Description
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
show vlt brief — display the delay-restore value.
Enter the respective VLT port-channel number of the peer device.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
Virtual Link Trunking (VLT) 1689