Adj 11.3-171 Stapler Anvil Alignment - Xerox WorkCentre 5790 Series Service Manual

ADJ 11.3-171 Stapler Anvil Alignment

Parts List on PL 11.168
Purpose
To ensure the correct alignment of the stapler anvil to the stapler throat.
Special Tools Required
Stapler alignment tool, supplied with the HVF BM, located on the left of the BM frame.
NOTE: This procedure illustrates the front stapler. The procedure for adjusting the rear stapler
is identical.
Adjustment
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. To improve the access to the two clamp screws for the anvil, remove the tamper assem-
bly, REP 11.30-171.
2. Fully pull out the BM module. Remove the stapler cover(s), one screw on each. Pull the
stapler bracket handle and swing open the stapler bracket.
Xerox® WorkCentre® 5790 Family
WARNING
WARNING
3. Insert the alignment tool, Figure
Figure 1 Alignment tool insertion
May 2013
4-479
1.
1
Insert the stapler
2
alignment tool into
the stapler throat
Press the tool firmly into
place and slowly close
the stapler bracket
Repairs/Adjustments
ADJ 11.3-171