Removing The Stacker Tray (J0St41693); Rep 16.2.15 Stacker Elevator Motor; Rep 16.2.16 Stacker Tray - Xerox WorkCentre 5222 Service Manual

REP 16.2.15 Stacker Elevator Motor

Parts List on PL 23.7
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Switch off the power and disconnect the power cord.
2. Remove the Finisher Rear Upper Cover.
3. Disconnect P/J8988 on the Finisher Control PWB.
4. Release the wires from the cable clamps.
5. Remove the wires from the wire guide, remove the screws (2) and move the wire guide to
one side.
6. Remove the screws (2) from the motor mount using a 5.5 mm combination wrench.
7. Remove the Stacker Elevator Motor.
Replacement
Install in reverse order of removal procedure.
Launch Version
WorkCentre 5225, 5230
WARNING
(REP 16.2.3)

REP 16.2.16 Stacker Tray

Parts List on PL 23.7
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Remove the following:
a. Booklet Maker Assembly (if installed).
b. Front Cover Assembly.
c. Rear Upper Cover.
2. Remove the Stacker Tray.
a. Remove the Screws (4).
b. Remove the Stacker Tray.
Stacker Tray
Screws
Figure 1 Removing the Stacker Tray (j0st41693)
Replacement
Reverse the removal procedure for replacement.
February, 2008
4-155
WARNING
(REP 22.4.2)
(REP 16.2.2)
(REP 16.2.3)
(Figure 1)
Repairs and Adjustments
REP 16.2.15, REP 16.2.16