Ipv6 Pim Sparse-Mode Passive - Allied Telesis x310-26FT Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 -
IPV PIM SPARSE MODE PASSIVE

ipv6 pim sparse-mode passive

Overview Use this command to enable and disable PIM-SMv6 passive mode operation for
local members on a VLAN interface.
Use the no variant of this command to disable PIM-SMv6 passive mode operation
for local members on a VLAN interface.
Syntax ipv6 pim sparse-mode passive
no ipv6 pim sparse-mode passive
Mode Interface Configuration for a VLAN interface.
Usage Passive mode essentially stops PIM-SMv6 transactions on the interface, allowing
only the MLD mechanism to be active.
awplus#
Examples
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
awplus#
awplus(config)#
awplus(config-if)#
C613-50103-01 REV A
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
ipv6 enable
ipv6 pim sparse-mode passive
configure terminal
interface vlan2
no ipv6 pim sparse-mode passive
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1296