Table of Contents
Advertisement
MLD
MLD S
C
AND
NOOPING
OMMANDS
6
IPV
MLD SNOOPING QUERIER
ipv6 mld snooping querier
Overview
Use this command to enable MLD querier operation on a subnet (VLAN) when no
multicast routing protocol is configured in the subnet (VLAN). When enabled, the
MLD Snooping querier sends out periodic MLD queries for all interfaces on that
VLAN.
Use the no variant of this command to disable MLD querier configuration.
ipv6 mld snooping querier
Syntax
no ipv6 mld snooping querier
Mode
Interface Configuration for a specified VLAN interface.
Usage
This command can only be configured on a single VLAN interface - not on multiple
VLANs.
The MLD Snooping querier uses the 0.0.0.0 Source IP address because it only
masquerades as an MLD querier for faster network convergence.
The MLD Snooping querier does not start, or automatically cease, the MLD Querier
operation if it detects query message(s) from a multicast router. It restarts as an
MLD Snooping querier if no queries are seen within the other querier interval.
Do not enable MLD Snooping querier if you have already enabled MLD on your
device.
Do not enable MLD Snooping querier on your device and then enable MLD
afterwards.
awplus#
Example
awplus(config)#
awplus(config-if)#
C613-50103-01 REV A
configure terminal
interface vlan2
ipv6 mld snooping querier
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1162
Advertisement
Table of Contents
