Ipv6 Mld Querier-Timeout - Allied Telesis x310-26FT Command Reference Manual

MLD MLD S C
AND NOOPING OMMANDS
6 -
IPV MLD QUERIER TIMEOUT

ipv6 mld querier-timeout

Overview Use this command to configure the timeout period before the router takes over as
the querier for the interface after the previous querier has stopped querying.
Use the no variant of this command to restore the default.
Syntax ipv6 mld querier-timeout <seconds>
no ipv6 mld querier-timeout
Default 255 seconds
Mode Interface Configuration for a specified VLAN interface or a range of VLAN
interfaces.
Usage This command applies to interfaces configured for MLD Layer-3 multicast
protocols.
Example The following example configures the router to wait 120 seconds from the time it
received the last query before it takes over as the querier for the interface:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
Related ipv6 mld query-interval
Commands
C613-50103-01 REV A
Parameter Description
<seconds>
Number of seconds that the router waits after the previous querier
has stopped querying before it takes over as the querier. Valid values
are from 2 to 65535 seconds.
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ipv6 enable
ipv6 mld querier-timeout 120
1153