Ip Rip Split-Horizon - Allied Telesis x310-26FT Command Reference Manual

RIP C
OMMANDS
-
IP RIP SPLIT HORIZON

ip rip split-horizon

Overview Use this command to turn on the split-horizon mechanism on the interface.
Use the no variant of this command to disable this mechanism.
Syntax ip rip split-horizon [poisoned]
no ip rip split-horizon
Default Split horizon poisoned
Mode Interface Configuration for a VLAN interface.
Usage Use this command to avoid including routes in updates sent to the same gateway
from which they were learned. Without the poisoned parameter, using this
command causes routes learned from a neighbor to be omitted from updates sent
to that neighbor. With the poisoned parameter, using this command causes such
routes to be included in updates, but sets their metrics to infinity. This advertises
that these routes are not reachable.
Example To turn on split horizon poisoned on vlan2, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50103-01 REV A
Parameter Description
poisoned
Performs split-horizon with poison-reverse. See "Usage" below for
more information.
configure terminal
interface vlan2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ip rip split-horizon poisoned
809