Vty Ipv6 Access-Class (Named) - Allied Telesis x310-26FT Command Reference Manual

IP 6 S A C
V OFTWARE CCESS ONTROL
6 - (
VTY IPV ACCESS CLASS NAMED

vty ipv6 access-class (named)

Overview For IPv6, use this command to set a standard named software access list to be the
management ACL. This is then applied to all available VTY lines for controlling
remote access by Telnet and SSH. This command allows or denies packets
containing the IPv6 addresses included in the ACL to create a connection to your
device.
ACLs that are attached using this command have an implicit 'deny-all' filter as the
final entry in the ACL. A typical configuration is to permit a specific address, or
range of addresses, and rely on the 'deny-all' filter to block all other access.
Use the no variant of this command to remove the access list.
vty ipv6 access-class <access-name>
Syntax
no vty ipv6 access-class [<access-name>]
Mode Global Configuration
Examples To set the named standard access-list named access-ctrl to be the IPv6
management ACL, use the following commands:
awplus#
awplus(config)#
To remove access-ctrl from the management ACL, use the following commands:
awplus#
awplus(config)#
Output Figure 36-3: Example output from the show running-config command
Related show running-config
Commands
vty access-class (numbered)
C613-50103-01 REV A
L (ACL) C
IST OMMANDS
)
Parameter Description
<access-name>
Specify an IPv6 standard software access-list name
configure terminal
vty ipv6 access-class access-ctrl
configure terminal
no vty ipv6 access-class access-ctrl
awplus#showrunning-config|grep access-class

vty ipv6 access-class access-ctrl
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1482