Ipv6 Pim Rp-Candidate - Allied Telesis x310-26FT Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 -
IPV PIM RP CANDIDATE

ipv6 pim rp-candidate

Overview Use this command to make the device an RP (Rendezvous Point) candidate, using
the IPv6 address of the specified VLAN interface.
Use the no variant of this command to stop the device from being an RP candidate.
Syntax ipv6 pim rp-candidate <interface> [priority <priority>|interval
<interval>|grouplist <accesslist>]
no ipv6 pim rp-candidate [<interface>]
Default The priority value for a candidate RP is 192 by default until specified using the
priority parameter.
Mode Global Configuration
Usage Note that issuing the command ipv6 pim rp-candidate <interface> without
optional priority, interval, or grouplist parameters will configure the candidate
RP with a priority value of 192.
Examples To specify a priority of 3, use the following commands:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
To use the ACL named G2 to specify the group prefixes that are advertised in
association with the RP address, use the following commands:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
2001:db8::/128
awplus(config)#
C613-50103-01 REV A
Parameter Description
<interface>
Specify a VLAN interface name.
<priority>
Specify the priority for the RP candidate in the range 0 to 255.
<interval>
Specify a candidate RP advertisement interval in the range 1 to
16383 (seconds).
<accesslist> Specify a Standard or an Extended software IPv6 access list name.
See the
for supported IPv6 ACLs.
configure terminal
ipv6 forwarding
ipv6 multicast-routing
ipv6 pim rp-candidate vlan2 priority 3
configure terminal
ipv6 forwarding
ipv6 multicast-routing
ipv6 access-list standard G2 permit
ipv6 pim rp-candidate vlan2 group-list G2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPv6 Software Access Control List (ACL) Commands chapter
1291