Ip Pim State-Refresh Origination-Interval - Allied Telesis x310-26FT Command Reference Manual

PIM-DM C
OMMANDS
-
IP PIM STATE REFRESH ORIGINATION

ip pim state-refresh origination-interval

Overview This command configures a PIM state-refresh origination-interval value. The
origination interval is the number of seconds between PIM state refresh control
messages. The default is 60 seconds.
Use the no variant of this command to return the origination interval to the
default.
ip pim state-refresh origination-interval <interval>
Syntax
no ip pim state-refresh origination-interval
Default The state-refresh origination-interval is set to 60 seconds by default, and is reset
using negation.
Mode Interface Configuration for a VLAN interface.
awplus#
Example
awplus(config)#
awplus(config-if)#
C613-50103-01 REV A
-
INTERVAL
Parameter Description
<interval>
<1-100> The integer value in seconds (no fractional seconds
accepted). The default state-refresh origination-interval value is
60.
configure terminal
interface vlan2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ip pim state-refresh origination-interval 65
1341